A better alternative to commercial roof replacement
Is your commercial single-ply roof starting to deteriorate? If you're looking to restore its performance without the high cost of replacement, turn to Pacific Commercial Roofing.
Our team of professionals will install an ASTEC® Re-Ply Roofing System directly overyour existing roof, which eliminates the tear-off costs, landfill fees, and extended facility disruptions that are often associated with a roof replacement. Why pay more if you don't have to?
Learn more about our roof re-ply process
1. Prepare surface - We pressure wash you old roof surface to eliminate loose material and repair substrate, blisters, and cracks as needed. All rubber surfaces are cleaned with an EPDM primer.
2. Seal seam - We'll reinforce all of your roof, vent, duct, and flashing seams and laps with high tensile fabric or BBT Butyl-back tape. These areas are then saturated with ASTEC® Base Sealer #2000.
3. Prime and seal surface - We will apply one or two layers of ASTEC® Base Sealer #2000 for rubber. This bonding sealer applies as a fluid, which fills all cracks and cures as a seamless, pliable membrane over your entire roof.
4. Apply core layer - At this point, we will apply the first layer of ASTEC® Re-Ply #2000 Finish Layer. It will bond with the ASTEC® Re-Ply Base Sealer #2000 and provide a monolithic core base for the final surface. 5. Apply surface layer - The final ASTEC® Re-Ply #2000 Finish Layer is now applied to your roof. The new surface will be a seamless, titanium white ply of highly reflective roofing. It will be waterproof, pliable, and virtually impervious to airborne corrosives over years of hostile environmental conditions.
Please note that this is the typical process for single-ply roofs. Products and procedures may vary depending on roof type and condition. Only ASTEC® detailed specification will be approved on any ASTEC® roofing project.
Save money with our commercial roof recoating services
Get your free commercial roof inspection and estimate today.